In some ways, this video tutorial is reminiscent of the one I shared a few weeks ago about how to fix your broken home.
But, as it turns out, the instructions are a bit different in how you apply tape and use glue to repair a broken house.
To make things simple, here are the steps to follow:Cut a 1×4 inch piece of foam.
Tape it around the outside of the house and the inside.
Glue it to the inside and the outside.
Cut a piece of tape around the inside of the home.
Glued it to both sides.
The instructions for how to glue the two pieces are a little different than the ones I shared above.
To apply the glue, put your finger on the glue and gently press it into the glue.
Apply the glue to the two sides.
If you can’t get the glue in, you can gently pull the tape back and forth.
You may have to repeat this a couple of times to get the two glued together.
Once both glued together, carefully apply the tape to the back and sides of the roof.
The tape should be snug, but not too tight to bend it.
Apply a small amount of glue to each corner of the glue wall, starting with the back wall.
The glue should stay on the tape for a couple minutes, and then the tape should loosen up and fall off.
If the glue doesn’t loosen up enough, try pulling the tape and tape back.
You should be able to push the tape off.
Repeat the process until the tape is completely loose.
You’ll notice that the glue on the back of the tape wall doesn’t stick very well to the sides of your house.
That’s because it’s made of polyethylene, a type of plastic.
The polyethyl and the tape are sandwiched together, which can make glue very sticky.
This sticky glue will be difficult to remove.
You’ll also notice that there is a lot of glue inside the house, but it won’t stick to the tape.
You can still get it off the tape, but you will need to push harder to get it out.
This video tutorial shows how to apply the polyethyl glue to both the sides.
As you can see, you need to apply a little bit of glue at the top and bottom of each corner.
Apply glue to all four corners of the frame.
You should now be able just to push a couple more inches off the edge of the polyester foam.
The glue is easy to remove, but the polystyrene that you put on the inside is very sticky and won’t be able be removed.
When the glue is off, you’ll notice the frame is just like any other wooden frame.
Once you get the frame off, the glue will slip off easily and fall away.
To glue the inside wall of the video house, put tape around each corner, and you should be good to go.
To attach the foam frame to the frame, put glue in the corners, and apply glue to any other corners of both the frame and the foam.
You can glue the foam around the edges of the outside and glue the top of the foam into the outside walls.
You will also need to glue one of the corners onto the foam wall, as shown above.
The finished frame looks a bit like a balloon frame.
You don’t have to worry about the foam sticking to the outside when the frame isn’t in use, as the foam is just attached to the foam with glue.
If you have any questions about how you can fix a home or how to make a DIY video tutorial, feel free to contact me at [email protected]